diff options
Diffstat (limited to 'sys/contrib/dev/ath/ah_soc.h')
-rw-r--r-- | sys/contrib/dev/ath/ah_soc.h | 110 |
1 files changed, 0 insertions, 110 deletions
diff --git a/sys/contrib/dev/ath/ah_soc.h b/sys/contrib/dev/ath/ah_soc.h deleted file mode 100644 index e3d0c53a276c..000000000000 --- a/sys/contrib/dev/ath/ah_soc.h +++ /dev/null @@ -1,110 +0,0 @@ -/*- - * Copyright (c) 2006-2008 Sam Leffler, Errno Consulting, Atheros - * Communications, Inc. All rights reserved. - * - * Redistribution and use in source and binary forms are permitted - * provided that the following conditions are met: - * 1. The materials contained herein are unmodified and are used - * unmodified. - * 2. Redistributions of source code must retain the above copyright - * notice, this list of conditions and the following NO - * ''WARRANTY'' disclaimer below (''Disclaimer''), without - * modification. - * 3. Redistributions in binary form must reproduce at minimum a - * disclaimer similar to the Disclaimer below and any redistribution - * must be conditioned upon including a substantially similar - * Disclaimer requirement for further binary redistribution. - * 4. Neither the names of the above-listed copyright holders nor the - * names of any contributors may be used to endorse or promote - * product derived from this software without specific prior written - * permission. - * - * NO WARRANTY - * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS - * ''AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT - * LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, - * MERCHANTIBILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. - * IN NO EVENT SHALL THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE - * FOR SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT - * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF - * USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND - * ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, - * OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT - * OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF - * SUCH DAMAGES. - * - * $Id: //depot/sw/branches/sam_hal/ah_soc.h#4 $ - */ -#ifndef _ATH_AH_SOC_H_ -#define _ATH_AH_SOC_H_ -/* - * Atheros System on Chip (SoC) public definitions. - */ - -/* - * This is board-specific data that is stored in a "known" - * location in flash. To find the start of this data search - * back from the (aliased) end of flash by 0x1000 bytes at a - * time until you find the string "5311", which marks the - * start of Board Configuration. Typically one gives up if - * more than 500KB is searched. - */ -struct ar531x_boarddata { - u_int32_t magic; /* board data is valid */ -#define AR531X_BD_MAGIC 0x35333131 /* "5311", for all 531x platforms */ - u_int16_t cksum; /* checksum (starting with BD_REV 2) */ - u_int16_t rev; /* revision of this struct */ -#define BD_REV 4 - char boardName[64]; /* Name of board */ - u_int16_t major; /* Board major number */ - u_int16_t minor; /* Board minor number */ - u_int32_t config; /* Board configuration */ -#define BD_ENET0 0x00000001 /* ENET0 is stuffed */ -#define BD_ENET1 0x00000002 /* ENET1 is stuffed */ -#define BD_UART1 0x00000004 /* UART1 is stuffed */ -#define BD_UART0 0x00000008 /* UART0 is stuffed (dma) */ -#define BD_RSTFACTORY 0x00000010 /* Reset factory defaults stuffed */ -#define BD_SYSLED 0x00000020 /* System LED stuffed */ -#define BD_EXTUARTCLK 0x00000040 /* External UART clock */ -#define BD_CPUFREQ 0x00000080 /* cpu freq is valid in nvram */ -#define BD_SYSFREQ 0x00000100 /* sys freq is set in nvram */ -#define BD_WLAN0 0x00000200 /* Enable WLAN0 */ -#define BD_MEMCAP 0x00000400 /* CAP SDRAM @ memCap for testing */ -#define BD_DISWATCHDOG 0x00000800 /* disable system watchdog */ -#define BD_WLAN1 0x00001000 /* Enable WLAN1 (ar5212) */ -#define BD_ISCASPER 0x00002000 /* FLAG for AR2312 */ -#define BD_WLAN0_2G_EN 0x00004000 /* FLAG for radio0_2G */ -#define BD_WLAN0_5G_EN 0x00008000 /* FLAG for radio0_2G */ -#define BD_WLAN1_2G_EN 0x00020000 /* FLAG for radio0_2G */ -#define BD_WLAN1_5G_EN 0x00040000 /* FLAG for radio0_2G */ - u_int16_t resetConfigGpio; /* Reset factory GPIO pin */ - u_int16_t sysLedGpio; /* System LED GPIO pin */ - - u_int32_t cpuFreq; /* CPU core frequency in Hz */ - u_int32_t sysFreq; /* System frequency in Hz */ - u_int32_t cntFreq; /* Calculated C0_COUNT frequency */ - - u_int8_t wlan0Mac[6]; - u_int8_t enet0Mac[6]; - u_int8_t enet1Mac[6]; - - u_int16_t pciId; /* Pseudo PCIID for common code */ - u_int16_t memCap; /* cap bank1 in MB */ - - /* version 3 */ - u_int8_t wlan1Mac[6]; /* (ar5212) */ -}; - -/* - * Board support data. The driver is required to locate - * and fill-in this information before passing a reference to - * this structure as the HAL_BUS_TAG parameter supplied to - * ath_hal_attach. - */ -struct ar531x_config { - const struct ar531x_boarddata *board; /* board config data */ - const char *radio; /* radio config data */ - int unit; /* unit number [0, 1] */ - void *tag; /* bus space tag */ -}; -#endif /* _ATH_AH_SOC_H_ */ |