blob: 72546c61449a2885a3d88b453f0d2b07f896a28d (
plain) (
tree)
|
|
/*
* This supports the ENSONIQ AudioPCI board based on the ES1370.
*
* Copyright (c) 1998 Joachim Kuebart <joki@kuebart.stuttgart.netsurf.de>
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice immediately at the beginning of the file, without modification,
* this list of conditions, and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* 3. Absolutely no warranty of function or purpose is made by the author
* Joachim Kuebart.
* 4. Modifications may be freely made to this file if the above conditions
* are met.
*
* $Id$
*/
#ifndef _ES1370_REG_H
#define _ES1370_REG_H
#define ES1370_REG_CONTROL 0x00
#define ES1370_REG_STATUS 0x04
#define ES1370_REG_UART_DATA 0x08
#define ES1370_REG_UART_STATUS 0x09
#define ES1370_REG_UART_CONTROL 0x09
#define ES1370_REG_UART_TEST 0x0a
#define ES1370_REG_MEMPAGE 0x0c
#define ES1370_REG_CODEC 0x10
#define CODEC_INDEX_SHIFT 8
#define ES1370_REG_SERIAL_CONTROL 0x20
#define ES1370_REG_DAC1_SCOUNT 0x24
#define ES1370_REG_DAC2_SCOUNT 0x28
#define ES1370_REG_ADC_SCOUNT 0x2c
#define ES1370_REG_DAC1_FRAMEADR 0xc30
#define ES1370_REG_DAC1_FRAMECNT 0xc34
#define ES1370_REG_DAC2_FRAMEADR 0xc38
#define ES1370_REG_DAC2_FRAMECNT 0xc3c
#define ES1370_REG_ADC_FRAMEADR 0xd30
#define ES1370_REG_ADC_FRAMECNT 0xd34
#define DAC2_SRTODIV(x) (((1411200 + (x) / 2) / (x) - 2) & 0x1fff)
#define DAC2_DIVTOSR(x) (1411200 / ((x) + 2))
#define CTRL_ADC_STOP 0x80000000 /* 1 = ADC stopped */
#define CTRL_XCTL1 0x40000000 /* SERR pin if enabled */
#define CTRL_OPEN 0x20000000 /* no function, can be read and
* written */
#define CTRL_PCLKDIV 0x1fff0000 /* ADC/DAC2 clock divider */
#define CTRL_SH_PCLKDIV 16
#define CTRL_MSFMTSEL 0x00008000 /* MPEG serial data fmt: 0 = Sony, 1
* = I2S */
#define CTRL_M_SBB 0x00004000 /* DAC2 clock: 0 = PCLKDIV, 1 = MPEG */
#define CTRL_WTSRSEL 0x00003000 /* DAC1 clock freq: 0=5512, 1=11025,
* 2=22050, 3=44100 */
#define CTRL_SH_WTSRSEL 12
#define CTRL_DAC_SYNC 0x00000800 /* 1 = DAC2 runs off DAC1 clock */
#define CTRL_CCB_INTRM 0x00000400 /* 1 = CCB "voice" ints enabled */
#define CTRL_M_CB 0x00000200 /* recording source: 0 = ADC, 1 =
* MPEG */
#define CTRL_XCTL0 0x00000100 /* 0 = Line in, 1 = Line out */
#define CTRL_BREQ 0x00000080 /* 1 = test mode (internal mem test) */
#define CTRL_DAC1_EN 0x00000040 /* enable DAC1 */
#define CTRL_DAC2_EN 0x00000020 /* enable DAC2 */
#define CTRL_ADC_EN 0x00000010 /* enable ADC */
#define CTRL_UART_EN 0x00000008 /* enable MIDI uart */
#define CTRL_JYSTK_EN 0x00000004 /* enable Joystick port (presumably
* at address 0x200) */
#define CTRL_CDC_EN 0x00000002 /* enable serial (CODEC) interface */
#define CTRL_SERR_DIS 0x00000001 /* 1 = disable PCI SERR signal */
#define SCTRL_P2ENDINC 0x00380000 /* */
#define SCTRL_SH_P2ENDINC 19
#define SCTRL_P2STINC 0x00070000 /* */
#define SCTRL_SH_P2STINC 16
#define SCTRL_R1LOOPSEL 0x00008000 /* 0 = loop mode */
#define SCTRL_P2LOOPSEL 0x00004000 /* 0 = loop mode */
#define SCTRL_P1LOOPSEL 0x00002000 /* 0 = loop mode */
#define SCTRL_P2PAUSE 0x00001000 /* 1 = pause mode */
#define SCTRL_P1PAUSE 0x00000800 /* 1 = pause mode */
#define SCTRL_R1INTEN 0x00000400 /* enable interrupt */
#define SCTRL_P2INTEN 0x00000200 /* enable interrupt */
#define SCTRL_P1INTEN 0x00000100 /* enable interrupt */
#define SCTRL_P1SCTRLD 0x00000080 /* reload sample count register for
* DAC1 */
#define SCTRL_P2DACSEN 0x00000040 /* 1 = DAC2 play back last sample
* when disabled */
#define SCTRL_R1SEB 0x00000020 /* 1 = 16bit */
#define SCTRL_R1SMB 0x00000010 /* 1 = stereo */
#define SCTRL_R1FMT 0x00000030 /* format mask */
#define SCTRL_SH_R1FMT 4
#define SCTRL_P2SEB 0x00000008 /* 1 = 16bit */
#define SCTRL_P2SMB 0x00000004 /* 1 = stereo */
#define SCTRL_P2FMT 0x0000000c /* format mask */
#define SCTRL_SH_P2FMT 2
#define SCTRL_P1SEB 0x00000002 /* 1 = 16bit */
#define SCTRL_P1SMB 0x00000001 /* 1 = stereo */
#define SCTRL_P1FMT 0x00000003 /* format mask */
#define SCTRL_SH_P1FMT 0
#define STAT_INTR 0x80000000 /* wired or of all interrupt bits */
#define STAT_CSTAT 0x00000400 /* 1 = codec busy or codec write in
* progress */
#define STAT_CBUSY 0x00000200 /* 1 = codec busy */
#define STAT_CWRIP 0x00000100 /* 1 = codec write in progress */
#define STAT_VC 0x00000060 /* CCB int source, 0=DAC1, 1=DAC2,
* 2=ADC, 3=undef */
#define STAT_SH_VC 5
#define STAT_MCCB 0x00000010 /* CCB int pending */
#define STAT_UART 0x00000008 /* UART int pending */
#define STAT_DAC1 0x00000004 /* DAC1 int pending */
#define STAT_DAC2 0x00000002 /* DAC2 int pending */
#define STAT_ADC 0x00000001 /* ADC int pending */
#define CODEC_OMIX1 0x10
#define CODEC_OMIX2 0x11
#define CODEC_LIMIX1 0x12
#define CODEC_RIMIX1 0x13
#define CODEC_LIMIX2 0x14
#define CODEC_RIMIX2 0x15
#define CODEC_RES_PD 0x16
#define CODEC_CSEL 0x17
#define CODEC_ADSEL 0x18
#define CODEC_MGAIN 0x19
#define ES_BUFFSIZE 0x20000 /* We're PCI! Use a large buffer */
#endif
|
